Luxtorious – Vulcan

Luxtorious watches tick on an automatic self-wind mechanism. It makes your watch sustainable in the long run. However, this luxurious mechanism can be fragile. Luxtorious finds it important that we inform you how to use your precious watch correctly.

Step 1

Unbox your watch and close the strap.

Step 2

Hold your watch in your left hand with the crown on the right side. Grab the case between your thumb and index finger. Place your three remaining fingers underneath the case for maximum stability.

Step 3

Pull out the crown with your right thumb and index finger. It has only 1 position.

Step 4

Set the correct time by rotating the crown clockwise(down). By turning it clockwise you make sure that the gear on the left starts ticking.

Step 5

Press the crown back in the case. If the gear has not started ticking as described in step 4, shake the watch a little until it starts to tick. When the gear ticks proceed to step 6.

Step 6

Now turn the crown counterclockwise. You now hear a wind-up sound. Turn it approximately 25 times. This creates enough tension on the spring for the full power reserve. (also read Tip 2)

Step 7

Wear your watch with pride and think about your time.

Tip 1

Keep your watch clean and shiny to make it last longer. Clean it with a jewellery cloth. A dry or moist towel does the trick as well.

Tip 2

If you use your watch every day you can skip step 6 most of the times. Just set the time following step 4 and your good to go. The spring is very sensitive so treat it with care.

Tip 3

Setting your time by turning the crown clockwise (step 4) will activate the gears. By turning it counterclockwise while the crown is pulled out you will slow down the gears. So when you twist an hour too far don’t worry, it’s sometimes better to keep turning clockwise.